ADVERTISEMENT

ADVERTISEMENT

Sensible Home: DIY storm windows a cost-effective option

Dear Jim: I have double-pane windows, but I think it would still help to add some storm windows. I am planning to make them myself. Are interior or exterior storm windows best and how can I design and build them? - Pete M.

Dear Jim: I have double-pane windows, but I think it would still help to add some storm windows. I am planning to make them myself. Are interior or exterior storm windows best and how can I design and build them? – Pete M.
Dear Pete: Since you already have double-pane windows, do-it-yourself storm windows are the most cost-effective option. The much higher cost of professionally installed storm windows would likely take a long time to payback with energy savings.
Storm windows save energy by creating a dead air space and by reducing air leakage. Although it is counterintuitive, a narrower air gap between the window glass and the storm is better.
If the air gap is more than one inch wide, circular air currents can develop within the air gap and it is no long a dead air space. When this happens, the insulation value of the air in the gap becomes ineffective. The only insulation value increase is from the plastic sheet or film, neither of which is very high.
In general, exterior storm windows which cover the entire window opening provide the greatest efficiency improvement. Even though the air gap may be wider than optimal, they reduce convection losses from the direct force of cold winter winds and reduce air leakage around and through the window.
The drawback to exterior storms is they must be built much stronger to resist the outdoor weather. Making interior storms is much easier and there are do-it-yourself kits available to help make them.
Using polyolefin shrink film from a storm window kit, but making your own wooden frame, works well. It can be removed each summer and reused for years. This looks much better than just sticking the tape on the window frame.
Make the rectangular storm frame about one-quarter inch smaller (room for weather-stripping) than the inside dimensions of the window opening. Paint both sides of the wood frame because the tape sticks better to a painted surface. Cut a piece of the shrink film and stick it to the tape.
Place another strip of tape over the film. Make narrow wood strips and staple them to the back side of the frame over this second strip of tape. This holds the shrink film much tighter when you shrink it with a blow dryer. With just a single piece of tape, the film may come loose and allow air leakage.
Red Devil has recently developed an interior storm window kit called “Snap N Seal.” It uses an adhesive-backed, plastic frame material which sticks to the window frame. Cut the frame pieces to fit the window. Cut a sheet of clear acrylic sheet (also blocks fading rays) to fit. The indoor edge of the frame snaps open and closed so the acrylic sheet can be removed during summer.
Another option, Indow windows, is a frameless acrylic storm window sheet with molded silicone weather-stripping around the edge. It is made to the exact size of the interior window opening. It is just pushed into the window opening close to the glass to create a small air gap each winter.
Dear Jim: I plan to reside in an old farm house and add wall insulation. I like the appearance of real cedar lap siding. What is the best method to nail it up over the insulation and sheathing? – Carol S.
Dear Carol: Using ring shank nails works well because they grip tightly and should not pop over time. Use galvanized steel or aluminum nails to eliminate rust stains. Drive the nail head in flush with the siding surface.
Locate the nails just above the edge of the piece of siding below so you never end up with nails through two pieces of siding. If you drive the nails up too far on the siding, it has a tendency to split.

Send inquiries to James Dulley, The Forum of Fargo-Moorhead, 6906 Royalgreen Drive, Cincinnati, OH 45244, or visit www.dulley.com

Related Topics: AGRICULTURE
What To Read Next
Host Thomas Evanella talks with Fargo Housing and Redevelopment Authority CEO Chris Brungardt about new affordable housing and a look at projects on the horizon.
Check out our roundup of business news and updates.
In this week's Business Beat podcast, we hear about a renovated Hannaford, North Dakota, building and a bus service connecting Fargo and MSP airports.
Members Only
“This will be the biggest international market in North Dakota and South Dakota,” says John Huynh, co-owner of the downtown store.